Using NX in preFL with C7ST-14D212 bluetooth-module

[Go4IT]

Hey guys, somebody asked me if this comibination work and i though yes. But after fitting he can use handsfree and speech-control, but does not see BT-audio buttons on NX. Strange, eh? Any ideas why? CCC is correct, Loop-plug is correct. He can bind his smartphone to the module and use phone, even on Convers+, but not BT audio.

[sanndo]

I have same problem with FX and after update fx to 4.1 bluetooth audio working fine. Did you try to update nx to 5.3 firm?

[Go4IT]

Sorry, forgott to mention that NX already is at SP 5.3

[DGAlexandru]

What editor do you use for CCC?
UC DS is not good - it misses some config options for BT
I use good old ELMConfig or ForScan - "USB with streaming for Nav only" or something like this.

[sanndo]

DGAlexandru is right. Did you check config with another soft? Or did you reset module?

[Go4IT]

ELMConfig is used for programming, Reset has been made.

[Go4IT]

I've found it with hint from a friend! It was just a silly mistake in my documentation, where i wrote to set "BT/VC High + USB + BTAudio + Nav" for NX/MCA and BT-Module with audio streaming. But that was wrong and instead it should be "BT/VC High + USB, and BTAudio for Nav only"

[amplified]

All working now then?

[Go4IT]

Yes, it‘s working.

[DGAlexandru]

I said the same thing "for nav only"